Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Cant find connector small enough

Status
Not open for further replies.
T

treez

Guest
Hello,
Hello, we need a wire to board connector, 2 way. Size less than 13mm x 8mm (length x width), and height less than 10mm
We need the connector (>0.5A) and rated to 400V at least. Though in nominal use it will have 75V between terminals.
This is the connector (Wago) we currently use and its too big......
Wago 2060-402/998-404 connector:
https://www.farnell.com/datasheets/...MIuJKv2sXw1wIVRrcbCh19bQMeEAAYASAAEgKaW_D_BwE

We simply cannot find anything, we have searched Wago, Pheonix, Molex, JST, etc, but nothing.
Any ideas appreciated?
 

Hi,

wurth has some connectors - especially designed for low voltage lightning applications.
Maybe this is what you are looking for.
But I don´t have partnumbers by hand.

Klaus
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top