Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[Move] GPRS not able to activate in neoway M590E modem

Status
Not open for further replies.

harshil.soni434

Newbie level 1
Joined
Nov 15, 2017
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
10
In client server socket communication, we followed below AT command sequence for communication.

AT+XISP=0
OK

AT+CGDCONT=1,"IP","internet"
OK

AT+XIIC=1
OK

AT+XIIC?
+XIIC: 0, 0.0.0.0
OK


In that sequence I tried to establish PPP link using (AT+XIIC=1) AT command and also received OK response. But when I tried to check the PPP link is successfully attached or not using (AT+XIIC?) AT command but always PPP link is not established properly.

I followed as per given in this document link : https://cdn.instructables.com/ORIG/FX6/UAHQ/IZ6CYGIU/FX6UAHQIZ6CYGIU.pdf

but getting this same issue
so how to resolve this type of issue?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top