Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

SIM808 GPRS connection issue

Status
Not open for further replies.

aleshmahajan

Newbie level 1
Joined
Oct 17, 2012
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,291
Hello,

I am using SIM808 in a project for a while and have this set of AT commands in use:

Code:
AT
AT+CREG?
AT+CGATT?
AT+SAPBR=3,1,"Contype","GPRS"
AT+SAPBR=3,1,"APN","airtelgprs.com"
AT+SAPBR=1,1
AT+HTTPINIT

which worked fine until I started getting problem with AT+SAPBR=1,1 which replies with an OK but the netlight starts blinking (According to datasheet it represent GPRS data transmission in process).:-|
Tried:bang::

  1. reset
  2. upgrade the SIM808 firmware(with and without user memory erase)
  3. Changed the module itself
  4. verified with 3 different SIM cards(Airtel, Airtel, TATADOCOMO: networks in India)

Suggestion are welcomed. Thank You :)
 
Last edited by a moderator:

Hello,

netlight starts blinking (According to datasheet it represent GPRS data transmission in process).:-|

Where in the manual does it say that?

This is normal and the LED is always blinking fast when GPRS is on(AT+SAPBR=1,..).
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top