truebs
Full Member level 5
Hello friends ,
i am using 74165 to convert parallel to serial , then 74164 to convert serial data into parallel which finally goes into a seven segment display.
In first case (parallel to serial ) ,i am simply giving 5V to 4 pins and 0V to other 4pins (i.e. 10101010 input ) .
But the problem is that i am not getting the output at seven segment.
Can some one please post some circuit similar to this .
or please give some link where i can read about it.
(datasheets are rather misleading)
Thanks !
i am using 74165 to convert parallel to serial , then 74164 to convert serial data into parallel which finally goes into a seven segment display.
In first case (parallel to serial ) ,i am simply giving 5V to 4 pins and 0V to other 4pins (i.e. 10101010 input ) .
But the problem is that i am not getting the output at seven segment.
Can some one please post some circuit similar to this .
or please give some link where i can read about it.
(datasheets are rather misleading)
Thanks !