Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Desoldering and soldering IC with power pad

Status
Not open for further replies.

Alan8947

Full Member level 4
Joined
Sep 21, 2016
Messages
215
Helped
9
Reputation
18
Reaction score
11
Trophy points
1,298
Activity points
3,746
Hi

I am looking for a rework station for soldering and desoldering of IC with power pad. That is IC with metal landing at the bottom for soldering onto the plane of the pcb for better heat conduction.

Thanks

Alan
 

Never did that before, but perhaps you should consider the same nozzle set used for desoldering BGA components, although most of them are sold for use with both SMD/BGA packages.
 

The Nice Ladies In The Lab used a small heat gun and
gravity. Although a temperature-tolerant vacuum wand
or gently applied tweezers might be easier than working
upside down.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top