robotech
Newbie level 1
Hy All!
I've read topics related Neoway M590 module, but i can't find answer about why my M590 module can not register the SIM to the network. Of course if i put SIM card to any other device (phone,tablet) works! No pin code setted either...
After startup Neoway says:
After this i ask the register status, it's sometimes
sometimes 0,2
but never 0,1
Regarding to AT command set 0,2 means connection refused by network
0,4 means unknown code (i think means unknown problem occoured).
When i check signal strength, it says:
what is not too bad... sometime i measured 5,99..
Please help me out, theoretically M590 need to handle all network provider's SIM
(This one is telenor).
I've read topics related Neoway M590 module, but i can't find answer about why my M590 module can not register the SIM to the network. Of course if i put SIM card to any other device (phone,tablet) works! No pin code setted either...
After startup Neoway says:
MODEM : STARTUP
+PBREADY
After this i ask the register status, it's sometimes
AT+CREG?
+CREG: 0,4
sometimes 0,2
but never 0,1
Regarding to AT command set 0,2 means connection refused by network
0,4 means unknown code (i think means unknown problem occoured).
When i check signal strength, it says:
AT+CSQ
+CSQ: 3,99
OK
what is not too bad... sometime i measured 5,99..
Please help me out, theoretically M590 need to handle all network provider's SIM
(This one is telenor).