Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

sim900 stopped responding when i sent at command "AT+CSCLK"

Status
Not open for further replies.
S

shashidhar1990

Junior Member level 1
Joined
Aug 25, 2015
Messages
18
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
120
HI,
i sent at command "AT+CSCLK" through hyper terminal and responded as ok. after that the sim900 is not at all responding to any of the commands.
what is the problem with at+csclk" command . i dont know what this command does actually.
please reply me . i need help .
 

Pull pin #3 of Your sim900 module (DTR pin) to the ground.
Then send a command "AT+CSCLK=0". That will power-off module's sleeping mode.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top