Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

S-parameter graph showing straight line in CST design

Status
Not open for further replies.
K

Kick

Full Member level 6
Joined
Sep 27, 2010
Messages
344
Helped
16
Reputation
32
Reaction score
15
Trophy points
1,298
Location
India,Bangalore
Activity points
3,170
Hi all,

I am new in CST STUDIO SUITE. I created a model of our PCB in CST and done the simulation,but result is strange,showing a straight line. If any of the CST experts see this post,please reply. My doubt is regarding discrete port setting, for antenna excitation I used ground layer. Is it ok? Should use power layer?

Thank you.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top