Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Application suggestion for Analog Electronics Laboratory Lessons

Status
Not open for further replies.

Alper özel

Member level 1
Joined
Feb 28, 2015
Messages
40
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Location
Turkey / Scotland
Activity points
487
Hi, I am currently assigned to design simple Analog circuits laboratory kits Like those below:

http://www.feedback-instruments.com...et_Basic_Electronic_Series_espial_10_2013.pdf

http://www.feedback-instruments.com...et_Basic_Electronic_Series_espial_10_2013.pdf

It has to cover the topics like diode applications(Half and full wave rectifier, Diode switches, diode clipping and clamping etc), Transistor Applications(current mirror, current source, phase splitter, astable multivibrator etc), Filter circuits(Low pass, active, band pass filters etc) and everything else about analog electronic. So I would appreciate any suggestion to make learning easier in laboratory lessons about analog electronics. Thank you already!
 

With just a brief glance at your two links, it seems to be a hardware kit that you can re-configure via software and view the results on the computer acting as a oscilloscope (CRO). There is no indication of what signal sources(real or virtual). Or even whether the simulated circuits and related to the plug in board, I.E. if you put a DVM across a component woulld it show what the CRO shows?
Frank
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top