Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Drivers compatibility: FT232MB and PL2303

Status
Not open for further replies.
Fragrance

Fragrance

Advanced Member level 4
Joined
Jul 26, 2002
Messages
1,190
Helped
248
Reputation
496
Reaction score
202
Trophy points
1,343
Location
East Of Earth
Activity points
8,933
hi

in those days i am working on usb based and power pic programmer my question is that is that both chip are same can they work on same driver or i required differ driver for pl2303 chip, as thse chip are available in my country if they are not same then i buy FT232MB
 

pl2303 direct driver

Of course each chip has its own driver. They are not interchangeable. I don't know if the Prolific chip is OK as I even can't get samples in my country. But I tested the FTDI chip for a commercial project and it's really good. No problem with serial Plug'n'Play, fast and some extra tuning features .... I can recommend it, but it's a little bit more expensive.


Mik
 

extra-pic и pl-2303

No, the drivers are complely diffrent. IMHO, the FTDI drivers are easier to use, you can access the chip either with virtual comm port, or with direct drivers, which allows you to access the chip using a dll. You can also use the FTDI in bitbang mode, this allows you to control each pin independently, as input or as output.

/pisoiu
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top