Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Partial scan chain using DFT compiler

Status
Not open for further replies.

farzaneh_2561

Member level 1
Joined
Jul 8, 2013
Messages
34
Helped
1
Reputation
2
Reaction score
0
Trophy points
6
Activity points
248
Hi every body,

I'm trying to insert partial scan chains using DFT compiler.
When I enter the command 'compile -scan', this warning shows up.

No scan equivalent exists for cell DFF_0/Q_reg (DFF_X1).

I'm using Nangateopencelllibrary 45 nm.
What are the conditions for equivalency of a DFF and a scan FF? Because I checked the lib file and there are different kinds of scan cells in it.
I also tried the procedure using a different library and there were no warnings. (I cant use this library:sad:)

Anybody knows what the problem might be?
Is there anyway ( like some kinds of commands) to force DFT compiler to use a specific scan cell?

Thanks.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top