Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Structural difference between buffer and higher drive strengh buffer of same height

Status
Not open for further replies.

ramesh28

Member level 3
Joined
May 21, 2013
Messages
57
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,670
Structural difference between buffer and higher drive strenght buffer of same height

Hello all,

As we come across standard cell library, we can find buffer of size 1X, 2X, 4X, 8X, 16X, and so on.. I know that drive strengh will be increases if we follow this order..
I observed that there is width difference between all of them.

Can anyone tell me what is stuctural difference between these buffer which having same height?


Thank you..
 
Last edited:

The difference is just the size of the output inverter.
 

Output inverter size means which parameters differs? at what proportion?

can you give detail idea?
 

Output inverter size means which parameters differs? at what proportion?

can you give detail idea?

The W/L ratio of both transistors. In the same proportion as the driver strength.
 
Thanx for reply erikl.

I just wanted to know as you tell difference between buffer and higher drive strength buffer is output inverter size. But if you consider any other standard cell like NAND, NOR, AND, XOR, etc in that case there may or may not output inverter then which is structural difference between them and higher drive strength cell.
 

It's always the output driver! In case of NAND & NOR, all 4 transistors are W/L-multiplied.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top