Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Query about annular rings

Status
Not open for further replies.

mayd85

Junior Member level 3
Joined
Apr 10, 2013
Messages
30
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,288
Activity points
1,505
Hi,

IPC-2221 standard talks about annular rings for plated through holes. It mentions three types, viz.

1) External Supported
2) External Unsupported
3) Internal Supported

I understand that Internal/External means it is on internal/external layer. But what is the difference between supported and unsupported annular rings?
 

The terminology is a bit cryptic. IPC-2221A clarifies explicitely that "unsupported holes" means non-plated holes.
 
  • Like
Reactions: mayd85

    mayd85

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top