Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Please see the load sharing circuit that attached. In the circuit, Source of Q1 is connected to LOAD. Is this correct? Only Drain should be connected to LOAD. Am I right or Wrong?
Why? The switch isn't intended to disconnect the load from the battery. It disconnects the battery when the external supply is active (and Vload > Vbat).
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
