Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Place ground in orCAD capture

Status
Not open for further replies.
H

Haier

Junior Member level 2
Joined
Oct 19, 2012
Messages
20
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,414
When I place GND in capture, it appears two libraries on the "place ground" dialog block which are" CAPSYM" and "Design Cache".
I have some questions as below:
1. CAPSYM: what's the difference between GND & GND_POWER ? how to use them?
2. Design Cache: why are there more than 5 GND in the cache while I just used 1 ?
 

Both are same.it refer to GND.If you want yo have two nets in design then use two different symbols otherwise use only one...

Right click on design cache and select cleacup cache..
 
  • Like
Reactions: Haier

    H

    Haier

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top