Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Pspice Error - "Less than 2 connections at node"

Status
Not open for further replies.

combatiente

Newbie level 2
Joined
Jan 28, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,291
I just started to use Orcad Pspice 9.1. I got this error. I can't understand why it occurs.
 
Last edited:

I guess there's a specific node reported with the error message...
 

Message reported node that connect 3k resistor and E2. Why?
 

According to the exercise schematic, you mixed up in- and output of the VCVS.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top