Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Specifications of FR4 Epoxy.

Status
Not open for further replies.

antennadesign54321

Member level 1
Joined
Nov 14, 2010
Messages
34
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
1,530
Hi ,
I would like to know what are the FR4 PCB's available in the market with permittivity & height. Please let me know lower,higher value of both.

thanks a lot
 

Beware that there are many different suppliers, which are interchanged by the PCB manufacturers frequently for cost reduction. Ans all have different dielectric constant and loss tangent. So in short you can only use FR4 in case you can live with these larger variations by taking it into account during the design phase.
 

hi
there are different widths for example:0.8mm,1.2mm,2mm and etc
I see that setting the εr=4.4 can be practical
tand=0.02
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top