Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

code for microcontroller to receive data from bluetooth

Status
Not open for further replies.
There is no code to directly recieive the Bluetooth data. Check your circuit for the interface betrween Microcontroller and the Bluietooth receiver. This could be probably SPI, USB, I2C or a parallel bus. Accordingy your code neds to be written..
 

Receiving data from a Bluetooth device is no different from getting data on the microcontroller's UART from any other source like a PC, or another microcontroller, if you use a serial bluetooth module like this one **broken link removed**

Just connect its TX, Rx to your controller thru a Maxim level shifter, and you are ready to go.

Regards,

Anand Dhuru
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top