Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Soldering station – do it yourself

Status
Not open for further replies.
V

Vermes

Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


This soldering station has fully adjustable temperature and interchangeable tips.
The housing was made of aluminum. It was created with two pieces of plate, the first is bottom and sides and the second is front. Descriptions were made by thermotransfer. The whole was protected with an acrylic spray varnish.
A few photos from the construction and the finished device:




Link to original thread – Stacja lutownicza by bartek
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top