Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Mentor Graphics PADS Ground Plane

Status
Not open for further replies.
D

djnik1362

Full Member level 2
Joined
Aug 9, 2010
Messages
136
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Location
IRAN
Activity points
2,374
Hi
In PADS Layout Reference mentioned that if you want to assign hole
plane to ground or power it is better to assign a layer to "Ground Plane"
or "Power Plane" instead of using "Pour Manager".

I use Ground Plane in my design but when i produce Gerbers
it seems there is no copper . May be i am wrong . I compare it
with my "Power Plane" .

Here it is my Gerbers for Ground and Power Planes :

Gerbers for Ground and Power Plane

Please check it and inform me if there is something wrong.
Thanks for your support.
 

djnik,


During gerber generation, the program asks if we want to connect all planes.
I also think it strange, due that definition should be done under design itself.

I already worked with PADS, however can´t open those files.
Could you attach them in a viewable format ?

+++
 

I believe your problem is that you are calling out negative planes in your gerber generation. If you are using pours this will not work. You will have to set your gerbers to split mixed.

Regards,
Eda
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top