Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

AD9858(dds) frequency sweep problem

Status
Not open for further replies.
B

banner

Member level 1
Joined
Oct 6, 2009
Messages
35
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
iran
Activity points
1,529
Hi
I am using AD9858 in the frequency sweep mode. the only bit that I have set for sweep is CFR<15> which enables freq. sweep and setting DFTW and DFRRW. SYSclk is 200MHz . but nothing happens and the output is a fix frequency based on FTW register(for 50MHz), I do not know what is the problem?. in addition, what will be the start and stop of ferq. sweeping if I do not send any signal on FUD pin.

tnx
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top