Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

555 timer astable multivibrator

Status
Not open for further replies.
E

electroboy

Member level 5
Joined
Dec 30, 2010
Messages
86
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,879
In the following astable multivibrator circuit,



in some books, it is mentioned that the duty cycle id

d=( R1+R2)/(R1+2*R2)

in some other books, it is mentioned

d= R2/(R1+2*R2)

which is correct? which one should i use if i want to design a circuit of particular duty cycle ?

please tell me whether duty cycle is Ton/(Ton+Toff) or Toff/(Ton+Toff)
 

which is correct? which one should i use if i want to design a circuit of particular duty cycle ?
please tell me whether duty cycle is Ton/(Ton+Toff) or Toff/(Ton+Toff)
Click to expand...

I think, it's your choice. That's also the reason, why both expressions for d exist.

In my opinion, you would define high output as "on" and duty cycle as Ton/(Ton+Toff).
In this case, the first expression applies: d=( R1+R2)/(R1+2*R2)
 
electroboy said:
please tell me whether duty cycle is Ton/(Ton+Toff) or Toff/(Ton+Toff)
Click to expand...

Normally when we say that the duty cycle is 10% we mean then the output is on for 10% of the period time so I think you should use Ton/(Ton+Toff)

Alex
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top