Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

increase dril hole size in orcad 9.1l

Status
Not open for further replies.

m_kavith

Member level 3
Joined
Jun 14, 2010
Messages
58
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
chennai
Activity points
1,638
i m using mosfet irfp460. its dimension in datasheet is TO247AD. i m using orcad 9.1, in this drill size is 1.8mm. after printed the pcb (non masking board),drill size in my pcb is below 1mm only. like this i give 3mm drill for my capacitor but in my pcb, it is 1mm only what can i do to increase drill size.how?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top