yahiatnt
Newbie level 4
Hi All,
I tried to search a lot on this subject but no luck :sad: So, I am looking for some help here at EDA.
What I want to do is:
1- how to configure V-USB to use bulk transfer in and out?
2- how to interface on host PC using WINUSB (I have already built drivers for control transfer, but what will be the difference with bulk transfer)?
3- I just want to transfer packets(128 Bytes) of raw data in both directions using bulk mode instead of control mode
4- Does WINUSB support bulk transfers for low-speed USB?
If someone can help on any or all of the above points go ahead, I will appreciate that :grin: specially with some example codes.
Thanks for your time and consideration.
Sincerely,
I tried to search a lot on this subject but no luck :sad: So, I am looking for some help here at EDA.
What I want to do is:
1- how to configure V-USB to use bulk transfer in and out?
2- how to interface on host PC using WINUSB (I have already built drivers for control transfer, but what will be the difference with bulk transfer)?
3- I just want to transfer packets(128 Bytes) of raw data in both directions using bulk mode instead of control mode
4- Does WINUSB support bulk transfers for low-speed USB?
If someone can help on any or all of the above points go ahead, I will appreciate that :grin: specially with some example codes.
Thanks for your time and consideration.
Sincerely,