Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help with Eagle: Snap to grid

Status
Not open for further replies.
C

coolhand21

Junior Member level 2
Joined
May 17, 2010
Messages
24
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,448
Hi I have a design in eagle, on my schematic my nets will not connect to the part. I tried zooming in to place the part on the grid and varies ulp from the eagle site same results. Are there any other solutions?

thanks
 

Can you please post the files?
 

Have you got a ratsnest? There is an option in the settings which sets how many pixels (I think) you can be from the end of the net where Eagle will finish off the tracking - check that setting.

Keith
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top