Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Question about SD-16 converters in MSP430

Status
Not open for further replies.

Sedat-G

Newbie level 6
Joined
Aug 5, 2010
Messages
11
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
East Lansing MI
Activity points
1,371
Hello everyone,

I am trying to understand the concept of SD-16 convertors and here is my question. If I am using SD-16 and internal voltage reference generator (1.2V), this means my sampling scale range corresponds to 0.6V if the microcontroller's gain is set to 1. So if the input of the ADC is more than 0.6V (=0xFFFF) which is out of the range, would the ADC convertor do the comparison?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top