sameh_yassin99
Member level 3
Dear all,
I've downloaded the FPGA design tool, ISE 11, from Xilinx web site
because they offer 30 days evaluation. I madethe following steps to install and run the ISE 11 tool:
1- Using the shell, I pointed to the location where the installation is located /home/Sameh/Ise_src
2- I typed ./xsetup, the the setup window appeard (I was so happy at this point)
3- The installation needed only 8 seconds to complete showing the message"Installtion complete"
4- I finally write in the shell "ise" from /Xilinx, but nothing happens "bash: command not found"
Please can you tell me what did I do wrong. I need explanation because I read the installtion relase notes
from Xilinx home "irn.pdf" and it wasn't helpful.
Bytheway, my kernel version is 2.6.x
Many thanks,
Sameh Yassin
I've downloaded the FPGA design tool, ISE 11, from Xilinx web site
because they offer 30 days evaluation. I madethe following steps to install and run the ISE 11 tool:
1- Using the shell, I pointed to the location where the installation is located /home/Sameh/Ise_src
2- I typed ./xsetup, the the setup window appeard (I was so happy at this point)
3- The installation needed only 8 seconds to complete showing the message"Installtion complete"
4- I finally write in the shell "ise" from /Xilinx, but nothing happens "bash: command not found"
Please can you tell me what did I do wrong. I need explanation because I read the installtion relase notes
from Xilinx home "irn.pdf" and it wasn't helpful.
Bytheway, my kernel version is 2.6.x
Many thanks,
Sameh Yassin