Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help me simulate a Hexagonal Unit Cell with Floquet port in HFSS

Status
Not open for further replies.
Feri4030

Feri4030

Junior Member level 3
Joined
Feb 20, 2009
Messages
31
Helped
13
Reputation
26
Reaction score
12
Trophy points
1,288
Location
Persia
Activity points
1,509
hexagonal unit cell

I'm trying to simulate a hexagonal unite cell with Floquet port in HFSS

1. I used a lattice coordination system, as shown in the picture? Is that correct?

**broken link removed**

2. I reduced the hexagonal unit cell to the rhombic unit cell (that rhombic vertices placed at the center of hexagonals ) but I got some error "Adaptive solution setup, process hf3d error: Error in pre-assembling element matrix."

Can any one help me?
 

hexagonal hfss floquet

I simulated the hexagonal mushroom Seveinpiper using the shown lattice coordination, The results was consistent with published results :D

any idea?
 
Hello,
I am also trying to simulate a Hexagonal Unit Cell with Floquet port in HFSS.
Did you use the Floquet port shown in the figure to simulate this structure?
Did you get a close result with the published papers?
Could you introduce one of the papers related to Hexagonal Unit Cell that I can use it as a reference?
Best Regards,
Alireza
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top