Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

parasitic impedance and capacitance

Status
Not open for further replies.

pisoiu

Advanced Member level 3
Joined
Dec 31, 2002
Messages
750
Helped
43
Reputation
86
Reaction score
21
Trophy points
1,298
Location
Romania
Activity points
7,883
parasitic impedance

Does anyone have any idea about the value of the parasitic impedance and parasitic capacitance of a 0 ohm resistor in 1206, 0805 and 0603 smd package?
 

hi,


You can measure S-parameters of the 0R resistor using network analyzer and model it yourself by using the measurement

eecly
 

eecly, thank you. I know how I can measure it, but I do not have such equipment. My question was if somebody knows approx. values from experience/previous measurements.
 

As a rule of thumb u can use the following model (I use this usually)

* Cp
* ,--------||-----------.
* | |
* | |
* | |
* | |
* | |
* o---o---L__|----((((------o----o
* | R L |
* | --
* Cs-- -- Cs
* -- |
* | |
* '--------GND----------'
typical values:
Cs 0.03-0.1 pF
Cp 0.05-0.2 pF
L 0.4-0.8 nH

rgds, Al

Sorry, the drawing doesn't look as I expected. At both pads Cs to ground, between pads series R-L, Cp in paralel to the pads
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top