Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CNC router Stepper driver design - help!

Status
Not open for further replies.
T

Thomasdj

Member level 5
Joined
Apr 13, 2008
Messages
82
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
2,113
what should be the spec router stepper

Hello,

I am new to steppers so need a little help designing a stepper driver/controller to my CNC router project. I need to drive/control 4 motors with the following specs:

2 x Astrosyn L189/4 Phase:
Phase Current 1.6A
Phase Res 2.65ohm
Phase Ind 4.75mH

2 x Simostep P50/3 Phase, - see picture:)

The two simostep should run synchromesh.

Thanks

Thomas
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top