Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ORCAD Capture: Problem with grid between Orcad 10.3 and 15.7

Status
Not open for further replies.
P

paulojfonseca

Newbie level 2
Joined
Sep 7, 2006
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,293
orcad capture 10.3

Hi to everyone,

I recently changed the version of my Orcad Capture software from 10.3 to 15.7.

When i open in Capture 15.7 drawings made in 10.3 version, i notice that the parts are not anymore alligned with the grid, there is a bit of offset in X and/ or Y direction. This is a bit anoying when i'm editing the schematics, because the pointer is allways snaping to the grid.

Is there any configuration i need to change in Capture 15.7 to solve this problem?

Regards
Paulo
 

orcad capture grid

Problem solved! I was using a Grid twice as big in ORCAD 15.7.
To Change it:

OPTIONS -> PREFERENCES -> GRID DISPLAY -> GRID SPACING
And aligne this value with the value in which the Schematic was developed.

Regards
Paulo
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top