Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Routing a Samtec QSH_DP connector in Altium

Status
Not open for further replies.

maxascent

Member level 2
Joined
Sep 22, 2005
Messages
52
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Location
England
Activity points
1,631
Hi

I was wondering if anyone had experience of routing any of the Samtec high speed connectors. I am using Altium designer and was looking for maybe an example image or maybe some tips. The connector I am using is the QSH DP

Cheers

Jon
 

Routing a Samtec QSH_DP connector in @ltium

What is the problem? I suggest that there is no special rule related to connector itself, you must apply the constraint based the specification of connected signals.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top