Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

import DXF file into Expedition

Status
Not open for further replies.

popoyboys

Advanced Member level 4
Joined
Feb 20, 2007
Messages
110
Helped
4
Reputation
8
Reaction score
2
Trophy points
1,298
Location
from the deepest roots of KAMOTE land
Activity points
1,967
i have a .dwg drawing which i intend to use in my layout job so i had to save it as a DXF file in AutoCAD 2007. i had to Import that DXF file into my layout job in Expedition, and i did successfully.

the only problem is that the imported DXF file seems to be way too small from its dimensions in the original DWG and DXF file in AutoCAD. the imported DXF drawing is even smaller than my smallest drill size.

any advice on how to do it right so i could have the correct drawing dimensions for my imported DXF file? is there a setting for AutoCAD and Expedition for this?
 

same thing happened on the PADs layout.
I never get a chance to use the Expedition, how good is it?
 

Hi, How to convert user layer to board outline?
 

If anyone of you have tutorails for expedition kindly upload it.
i am new to this tool and need to understand the design flow i have used pads earlier.

thanks
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top