Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Adaptive meshing in MWS!

Status
Not open for further replies.
K

KhangKhang

Member level 2
Joined
Jan 4, 2007
Messages
48
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
1,612
Hi all,
In solver setup, we have an adaptive meshing for stable and accuracy improvement!
Let's say if I use the Confinement Strategy "Energy Based" to run a quite complicated model. After some passes, I get a converge condition (Maximum Delta S<0.02, or Port impedance ~ 50ohm), and the meshcell is increased as a results!
I wonder how to use this condition for the next simulation without adaptive meshing! Mean, after modifying structure, I have to run adaptive mesh again that consuming a lot of time before reaching the stable-pass!
Thanks in advance for any help!
 

In simulating softwares almost every thing is bit tricky. Energy based adaptive mesh increase no. of meshing in those areas where it find high concentration of currents.
Although it offer for next modified structure but its good idea to use mesh adaptation when u r finalizing your results.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top