Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Altium Designer grids?

Status
Not open for further replies.

difflvl

Advanced Member level 4
Joined
Jun 14, 2006
Messages
110
Helped
12
Reputation
24
Reaction score
2
Trophy points
1,298
Activity points
1,985
Hi,

What snap, component and electrical grids do you guys typically use in AD?

Thanks
 

The grid settings depend entirely on what components there are on the board. If I'm routing traces between pins on a big IC, the snap and electrical grids are set to center traces between pads. If I'm doing a lot of closely spaced work, I might set the grids down to 1mil, or even tenths of a mil to give me more control over the specific area I'm working on.

The component grid depends on the density of the board and whether the device datasheets are in metric or imperial units. A typical medium to low density board might use 20mil or 25mil component grid.
 

    difflvl

    Points: 2
    Helpful Answer Positive Rating
@ltium Designer grids?

Thanks House_Cat.

Another question, MILS or MM which one is preferred for the grid?
 

Which units you use are up to you. If I'm working with components that use MM (metric) units on the datasheets, I usually toggle to metric display. If the datasheets use mils (imperial) units, I toggle to imperial display.

Most of my work is done in MILS, and I'm most comfortable thinking in Imperial units. You should use whatever works best for you.
 

    difflvl

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top