Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to add the outputs of a different voltage double ciruits

Status
Not open for further replies.

sandeepkiranv

Advanced Member level 4
Joined
Dec 26, 2015
Messages
102
Helped
10
Reputation
20
Reaction score
8
Trophy points
1,298
Activity points
1,884
hello everyone,

can you please help me to add the outputs of two voltage doubler circuits shown in the following figure.


REctifier.png
 

Rework one circuit so it outputs negative polarity. Connect your load across the two outputs. This method works if the two ground icons represent a single ground.

Or, the output stages can be connected similar to two batteries in series. This method works if the two circuits have separate grounds.
 
Hi,

Omit the upper GND (symbol).
Connect the lower end of R1 with the upper end of R1.

Klaus
 

    V

    Points: 2
    Helpful Answer Positive Rating
Hi,

Omit the upper GND (symbol).
Connect the lower end of R1 with the upper end of R1.

Klaus

Thank you sir, it worked out. can you please explain further on removing upper GND (symbol)...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top