Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

DC error: Syntax error at or near token 'enum_state'

Status
Not open for further replies.
I

ianalog

Junior Member level 1
Joined
Dec 4, 2006
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,372
when using DC, the error is shown , Syntax error at or near token 'enum_state',
the wire is set as ---reg [4:0] cstate ; why is error?
please help me.
thank you .
 

DC error, enum_state

Are you sure the error is caused by this line?
 

Re: DC error, enum_state

If the error is VER-294 in DC or any other VE* errors, it should be because of the reserved words used in RTL.

The reserved words should not be used in the RTL for signal names. Check the reserved words and modify them. Simple change in RTL use the escape character infront of the word , where it shows Error. Say for enum_state , use in RTL \enum_state every where it used in RTL.

Let us know if it works out... please let us know if you cant get rid of the error and what error ,DC is throwing out ...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top