Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with sending data between ZigBee modules using microcontrollers

Status
Not open for further replies.
E

E.muhammad

Newbie level 3
Joined
Jun 20, 2007
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,296
Dear Sir,

I'm using XBee modules. I want to send data using two modules by microcontrollers. This is what I did:
1- set API mode (AP =1), baud rate, source and destination addresses - only - in two modules by X-CTU software.
2- attached one module with my microcontroller and wrote a function to send data (in Tx Request API frame). Unfortunately, this didn't work and i didn't receive any data. That's all i did.

Please, tell me what is wrong in this? and how can i correct it?
Please, reply me as soon as possible.

Thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top