Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problem with detecting the Vref of testing pad when doing wafer level testing

Status
Not open for further replies.

fengluan

Junior Member level 3
Joined
Apr 14, 2006
Messages
27
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,463
For wafer level testing , when the probes are less than 70um deep, all bonding pad are ok, but can't detect the value of Vref from a testing pad, if probes more deeper, Vref can detect ,but a parameter is not correct, and not varied after trimming , maybe the ic has failures, the area of test and trim pad is less than bonding pad.
Thanks for any suggestion
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top