Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Can't see ACTIVE, NWELL, NSD nor PSD in GDS file of 0.18 based layout

Status
Not open for further replies.
I

ianalog

Junior Member level 1
Joined
Dec 4, 2006
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,372
hello, everyone.
I designing a layout based on 0.18u, the PP tool is SOC encounter. when i open the GDS file with virtuoso, I don't see the ACTIVE, NWELL, NSD and PSD. would you tell me is it correct ?
thank you !
 

Re: 018u layout question

you make sure you have copy the display.grf to your current path??
 

Re: 018u layout question

Your setup may be not loaeded properly
 

018u layout question

I have copy the display file, dont know why?

Added after 6 minutes:

down load sample file can see all layer, but the std_lib file can not be seen all layer. why?
 

018u layout question

If you have the display file, you must also enable the layers to see them !
 

Re: 018u layout question

be sure that the library is properly attached to tech file...
 

Re: 018u layout question

Hi guy:

May something wrong whan you load it.
You can log-out, than do it again following the right way.
Sometimes it can be solved.

best regards
dongqing
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top