Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Why LVS is showing that two nets are shorted while they are not?

Status
Not open for further replies.
J

jagadeesh2k1

Junior Member level 2
Joined
Dec 12, 2006
Messages
20
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,281
Activity points
1,429
In LVS it is showing two nets are shorted but actually It is not. Can any one explain the reason for the short.
 

doubt in LVS

Maybe they are shorted through substrate....
 

doubt in LVS

you have 2 nets far apart with the same name and you checked "joined same nets" ??
 

Re: doubt in LVS

agree with the former...
so you must carefully..
 

Re: doubt in LVS

I think If the outer connection is right, there must be short in the substrate
or any missing contact. The connection should be check carefully.Sometimes we did'nt realize small mistake. I agree with psmon, you should check wheter you have check the "join in same net" while do the LVS.
 

Re: doubt in LVS

hi
u can locate it using short locator if it is a smaller net
regards
analayout
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top