Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
fuzzy_boy,
If you define Qh as the transistor that supplies the more positive voltage to a load, and Ql as the transistor that supplies the more negative voltage to a load, then the circuit that turns Qh on (or off) is called the high side driver, and the circuit that turns Ql on (or off) is called the low side driver.
Regards,
Kral
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
