leeguoxian
Member level 3
Dear All
I'm p&r a design with scan chain.
First , I fixed all the timing violations in function mode,
then I switched to scan mode and fixed the timing .
But when I turned back to function mode, there were
setup violations .
It seems an iteration when design with function mode and scan mode.
Does anyone has a suggestion about this?
How can I made this 1-pass or less timing consuming ?
Any advice will help .
Thanks
I'm p&r a design with scan chain.
First , I fixed all the timing violations in function mode,
then I switched to scan mode and fixed the timing .
But when I turned back to function mode, there were
setup violations .
It seems an iteration when design with function mode and scan mode.
Does anyone has a suggestion about this?
How can I made this 1-pass or less timing consuming ?
Any advice will help .
Thanks