Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

multisim 9 : analysis with switch

Status
Not open for further replies.
N

neofrkh

Junior Member level 1
Joined
Feb 16, 2007
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,397
multisim switch

I designed a circuit using Time Delay Switch "TD_SW1" to switch voltage source from 12V to 6V for 0.5 sec, and get graph of current through a resistor from 0 to 2 sec. But while doing Analysis, the switch did not work.
Whole graph was plotted only considering 12V source.

So
How to plot this current graph using switch?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top