+ Post New Thread
Results 1 to 2 of 2
  1. #1
    Newbie level 4
    Points: 1,053, Level: 7

    Join Date
    Mar 2007
    Posts
    5
    Helped
    0 / 0
    Points
    1,053
    Level
    7

    Need some information

    Hi all:

    I need some information about a QAM Tx Rx system with a suitable channel,
    for my primary project , and Ineed a help to write the report of the project ,(what is suitable to start with ?)

    thanx

    •   AltAdvertisement

        
       

  2. #2
    Full Member level 5
    Points: 2,850, Level: 12

    Join Date
    Oct 2005
    Location
    South Africa
    Posts
    296
    Helped
    27 / 27
    Points
    2,850
    Level
    12

    Re: Need some information

    Hi,
    It is typical when writing a report to keep to a basic outline. In most cases this is something along the following lines.

    Abstract/Executive Summary -> Give a short synopsys of the entire project (max 1p)
    Introduction
    Literature Study
    Prelim Design
    Detailed Design
    Results / Experimental Obsevations
    Conclusion and Reccomendations
    References
    Appendix Contents Page
    Appendix A
    Appendix B

    This is a basic outline and it is possible that is can be shortened if required. If for instance you only perfor an experiment the design chapters would become something like "Experimental setup" and "Experimental procedures"

    I hoped this helped. You may also consult a book by BEER "Creative writing as an Engineer" it is very good.

    Cheers
    Slayer


    1 members found this post helpful.

--[[ ]]--