Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HOLE SIZE OF A PAD IN ORCAD

Status
Not open for further replies.
R

ronydc

Full Member level 3
Joined
Nov 17, 2005
Messages
166
Helped
4
Reputation
8
Reaction score
3
Trophy points
1,298
Activity points
2,612
dear friends.

does any one know.. how to change the : "hole" size inside a pad with ORCAD.?

PLEASE HELP. I AM STUCK BADLY.


I MEAN.. HOW CAN I DO. IT IF.. I WANA CHANGE THE 1N4007 DIODE WITH THE 5408 DIODE.. ( THT TIME WE NEED TO CHANGE THE "HOLE"SIZE OF A PAD... HOW CAN WE DO THT..?)
 

Yes :) It's easy,
Using the "Pin" tool, select the pad(s) you need to resize thier holes,
then, go to "Spread Sheet" in the tool bar
Select "Pad Stack" (Or another thing similar to it, i don't remember.. but i'm sure it's in the "spread sheet" menu u see now..)

You will find some items in a table selected, these items are the represent of pin(s) you selected above, edit thier properties as u want.. you will find it easy :)

I hope that helps you to solve the problem...
Best wishes,
Ahmad,
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top