Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How do I extract Net length or its corresponding Rc value?

Status
Not open for further replies.
R

Resistance

Member level 4
Joined
Dec 24, 2005
Messages
74
Helped
5
Reputation
10
Reaction score
2
Trophy points
1,288
Activity points
2,034
Hi all,

I want to know whether its possible to extract net length from a frontend tool preferebaly.. If so how?

Clear answer pls..

Regards
 

Pre-place and route, I don't think it's possible. Post-place and route it just depends on what tool you are using, but you need a routed def for the length and extraction for the RC.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top