Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with voltage in inverter design

Status
Not open for further replies.
E

ex4

Full Member level 2
Joined
Dec 28, 2004
Messages
120
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,298
Location
Jakarta, Indonesia
Activity points
958
hello,
i've been building inverter using IRF840 and IR2111 as the driver. I control the gate (EN and DIR)with PWM at 10KHz, to simulate AC voltage to drive 1phase ac induction motor connected at LOAD1 and LOAD2. I'm not getting enough voltage (just 50V). is there any mistake i make???
 

Inverter not working

I find nothing unusual with the Power Circuit. Maybe something wrong with your interconnections
 

Re: Inverter not working

mmm, have a look at the complete schematic (sorry if it is oversized)
 

Inverter not working

problem may be with your code,
what is your input volt ie 110v or 220v?
you are not using any pfc so if input volt is less same will effect output.
from the circuit i think it is 220v but then the filter capacitor you are used( c7 c8) should have a high volt type ( 400v or higher )

please check your actual line volt with a meter
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top