Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Ground isolation using opto couplers

Status
Not open for further replies.
T

TheKing

Newbie level 1
Joined
Dec 1, 2006
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
Dear friends..

I m using a +15V supply for two applications. the +15v is generated from a single supply. I need to isolate the +15V suppy grounds for the two applications. Is it possible to isolate using opto couplers...

If so schematics please...

Whether any other ways are there..

THanx is advance
 

Re: Ground Isolation

If you need to isolate two circuits you not only have to isolate grounds but +15V, too ..
Depending on power requirements you may consider 1W, 2W or as needed, miniature dc-dc converters .. Input:12-15V .. Output:15V ..

Here are some examples:
**broken link removed**

Regards,
IanP
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top