Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Which is the best software for PCB design?

Status
Not open for further replies.
good pcb design software

I'm not sure if the original poster was designing a board for mass manufacture. If so, don't forget design for manufacturing (DFM) - as different from the DRC that a board house will perform. You will be amazed how many little devilish details can send a fine-pitch BGA board into a flurry of expensive rework.

M.G.Rajan
www.eecalc.com
 

best pcb layout tools

i think Protues is the better
cos it easy to use !!!
 

what is the best pcb software

Here is a BEST PCB designing software. I have used it during my Engineering project..
"DIPTRACE"
use it and feel the difference
h**p://www.diptrace.com
 

best pcb designer software

orcad will bebetter.. as simple it is simple to use
 

best pcb design tools

i think Zuken's Cadstar And Cadence's Allegro are the best for complex boards.
cdatsar is more friendly to work with
 

best pcb layout design software

Only orcad is super hard in routing..
 

best pcb making software

pads ,board station,expedtion
 

best pcb schematic software

I worked with pads before,now on expedition,but i still prefer pads,its more user friendly...
 

best circuit pcb software

mentor graphics...........
 

best pcb programs

pads 2005 or pads 2007
 

diptrace teardrop

I am working Orcad many years ago, and i thing is very difficult to start with it.
But, if you spent many hours with a person who now and teaching you,
you will find that this program is very good.

-I had made a double layer PCB in the size of A4 paper with a IC with 200pins, and many others difficult designs.

-The only minus is that in the autoroute is not very clever. A human is necessary
for the routing. Is better not to try at all the autorouting procedure.
 

best pcb tool

mentor pads is easy to learn and very comfortalbe to work
 

best pcb design software

mentor pads is easy to learn and very comfortalbe to work

Added after 2 minutes:

mentors pads is easy to learn and very comfortable to use
 

top pcb design softwares

In my opinion ,there is no "best " but "better" !
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top